DAA PCC Mag Pouch SIG MPX

The DAA PCC Mag Pouch is a pistol caliber carbine magazine pouch body, made from tough fiber-reinforced nylon and injection molded for consistent fit.

Two adjustment screws allow you to set the retention force of your magazine to your preference. The pouch body is extra-long and deep, measuring  approx. 12cm or 4.75”. This ensures those 40, or 50 round magazines are held securely. A cutout window on the front of the pouch enables you to draw the magazine out a little earlier, despite its length. a beveled upper edge makes inserting the magazines easier and faster, for those “pickup” stages.
Two available pouch models are each designed for their intended magazine only – one for the Glock and the other for the SIG MPX. No spacers are used. The pouches are designed to hold the magazine with bullets pointing backwards, which is more compatible for the “fist-grab” reload technique used by most in PCC.

The pouch body is ambidextrous, allowing assembly of the belt-hanger’s ball-joint on either side, and at three optional height positions. The large ball-joint attaches with two mounting screws and custom-made steel T-slot nuts, for extra strength and durability. 

The DAA PCC magazine pouch Belt Hanger is made of fully-machined anodized aluminum, and designed to be as strong and sturdy as our holster ball-joint. It’s made much larger than our pistol pouches to withstand the additional forces generated by the very long magazines and popular horizontal carry angle. 
The ball-joint enables you to adjust your magazine to be orientated perfectly for your carry preference and reloading motion, helping you save time and gain consistency. The Belt-hanger bracket includes a removable spacer, fitting to a 1.5” or 1.75” Belt. The screws tighten down on a wide steel plate, to hold the large pouch securely on your rig